Personalised Swimming Bags - a tutorial

Tweet

Last week I made these swimming bags for my 2 daughters - and here is the promised tutorial - how to make them !

I chose to add the mesh in the bottom to allow the wet swimming gear to dry a little - and avoid smells!  

Materials needed:

Waterproof fabric - I used Ripstop Nylon for one, and an old shower curtain for the other!

2 pieces for main bag 48 x 42cm (19 x 16.5")

1 piece for drawstring strap 90 x 10cm (35.5 x 4")

1piece different colour waterproof fabric for name, and fusible webbing: 

30 x 10cm (12 x 4")

Mesh Fabric netting for base of bag.

 (I used an old mesh laundry bag)

42 x 20cm (16.5 x 8") 

NB I forgot to include my drawstring strap piece of fabric in this photo!

First you need to cut the name letters out of the second coloured piece of waterproof fabric.

Now I would highly recommend using fusible webbing to attach these letters to the main bag. Iron one side of the webbing to the back of the fabric - then you can write the letters on the paper backing and cut them out.

I was lazy and just drew the letters direct onto the fabric, cut them out and pinned in place.

Unfortunately this means the letters slip around a lot when trying to stitch them into place!

If you use the fusible webbing - you peel off the paper backing and iron them onto the main bag using a damp cloth over the letters.  This holds them in place and makes it much easer to stitch around the edges in either a tight zig zag stitch or the applique setting on your machine!

Now you're ready to put your bag together!

Pin the long side of the mesh/net fabric to the front main bag base - right sides together and stitch:

Repeat this with the other long side of the mesh/net fabric and the other main part of the bag:

If you have an overlocker (serger), it's a good idea to finish off the seam edges to prevent fraying.  If you don't have an overlocker (serger) you can use a zig zag stitch and trim the raw edge outside that.

You should now have a large rectangle with the mesh part in the centre.

It is a good idea to finish all four edges of this rectangle to prevent fraying.  Again if you have an overlocker (serger) use this around all edges. Otherwise you could turn the edges under twice and stitch with a regular machine to hide the raw edges.

Now you need to form the casing at the top of the bag for the drawstring.

Fold down both top edges - wrong sides together about 5cm (2").Pin and stitch along the edges.

Now fold the rectangle in half - right sides together to form your bag (inside out) Pin down the sides.

When you stitch the sides of the bag together - only stitch up as far as the casing. At the top, run some stitches sideways too and backwards and forwards a few times for extra strength:

Turn your bag out.

Now it's time to make the drawstring strap.

Take your long strip of waterproof fabric.

Fold both long edges in towards the centre, then both sides in again to completely enclose the raw edges. Then stitch down the edges to hold in place.  At either short end, fold the end under too to hide that raw edge.

Now all that's left is to add the drawstring to the bag!

Use a large safety pin or a nappy pin to push the strap through your casing Then tie the ends together:

And there you have one personalised swimming bag:

All ready to fill up with swimming gear:

And take to the pool..

Then you'll have to make one for sisters, brothers..friends...

For the downloadable PDF version of this tutorial, click here.

I hope you liked this tutorial.  

There are many over 100 more on my tutorials page if you'd like to take a look!