Creating my way to Success: Monster Pencil Case

My youngest daughter saw a pencil case in the shops similar to this and asked me if I could make her one!

Here's how I made it:

First my daughter chose the fabric - fur for the outside, and sparkly red velour for the inside.

Plus I needed a little black and white with some fusible webbing (Vliesofix) for the eyes, and of course a zip.

The size of the pencil case was just decided by laying the zip on it to judge the size of the mouth, and folding the fur in half.

(I cut the fur for this one was 35 x 32cm - 14" x 12.5")

I then cut an inner piece larger than one side of the pencil case as I wasn't sure how the slanted zip would affect how it turned out.

I also ironed the fusible webbing to one side of a scrap of black and white ready for the eyes:

So the first sewing step was to add the zip. I did photo the steps as I did it, but the fabric doesn't show the details too well.

I have another tutorial for how to add a zip like this here.

WARNING!! I managed to get my inner fabric the wrong side up here - you should place your inner and outer fabrics right sides facing when you draw, pin then stitch around the zip hole!

Once the zip mouth was in place, I cut shapes for the eyes from the black and white fabric and ironed then stitched them to the fur:

Next I trimmed the red inner fabric piece to the same size as one side of the outer pencil case (half the fur)

Then I cut another piece of red inner fabric the same size and stitched the two red pieces together around all four sides:

Finally, I folded the fur in half, right sides facing and stitched around all 4 edges, just leaving enough of a gap on one side to turn the case right sides out: